POLYGARD® SLT 3050

3mm Self-leveling Epoxy Floor System – Matt Finish
PRODUCT
APPLICATION

DESCRIPTION

3mm thick, medium to heavy-duty, self-leveling epoxy topping with matt finish.

USES

Suitable for use in medium to heavy traffic areas in all industries for clean rooms, laboratories, packing areas, assembly areas and medium duty areas in dry food manufacturing plants, plating and processing plants, pharmaceutical plants, wafer fabrication plants, electronics and computer manufacturing plants, printing and packaging plants, aircraft and aerospace industries.

BENEFITS

  • Matt finish hides substrate surface imperfections.
  • Solventless system, non-hardardous.
  • Chemical resistant.
  • Withstands medium forklift traffic.

TECHNICAL DATA

APPLICATION

SUBSTRATE REQUIREMENTS / PREPARATION

  • Concrete floor must be waterproofed and graded to specified levels and falls.
  • Concrete floor shall be cured for minimum twenty-one (21) days.
  • Chip off all cement droppings and cement overpours.
  • Degrease oil/grease contaminants with industrial degreaser.
  • Shotblast surfaces to achieve suitable surface profile.
  • Remove dust with industrial vacuum prior to application of coating.

APPLICATION PROCEDURES

  • Apply Polygard EP816 base coat.
  • Broadcast silica sand onto epoxy base coat until saturation. Allow six (6) hours drying time.
  • Remove excess silica sand.
  • Apply two (2) coats Polygard EP812 epoxy seal coats, allowing six (6) hours drying time in between coats.
  • Allow twenty-four (24) hours drying time before opening to light foot traffic and seven (7) days for chemical service conditions.

SAFETY REQUIREMENTS

Products contain epoxy resin and amines. Do not take internally. May irritate eyes and skin. Protective clothing and gloves are recommended to prevent sensitization to these materials. In case of eye contact, flush with soap and clean water and seek medical attention.

TECHNICAL ASSISTANCE

POLYGARD® SLT3050 Floor System should be applied by specialist applicators. Technical advice or assistance on suitability of system for specific application and end-user requirements are available from POLYMER INTERNATIONAL HOLDING PTE LTD. Individual Product Data Sheets are available upon request.

The statement provided concerning the materials shown are intended solely as a general guide for material usage and are believed to be true and accurate. Since the manner of use is beyond our control, POLYMER INTERNATIONAL HOLDING does not make nor does it authorize anyone to make any warranty of merchant ability or fitness for any purpose or any other warranty, guarantee or representation, express or implied, concerning this material except that it conforms to POLYMER INTERNATIONAL HOLDING product sample. Buyer and user except the product under these conditions and assume the risk of any failure, injury of person or property and loss or liability resulting from the handling, storage or use of the product, whether or not handled, stored or used in accordance with directions or specification. Under no circumstances shall POLYMER INTERNATIONAL HOLDING be liable for consequential or incidental damages arising from any breach of warranty. In all cases, POLYMER INTERNATIONAL HOLDING liability is limited, at POLYMER INTERNATIONAL HOLDING option, to the replacement of goods or their value, proven to be defective in manufacturing.