ECOGARD® MTX 5020

5mm Epoxy Mortar Topping – Smooth
PRODUCT
APPLICATION

DESCRIPTION

A 5mm thick heavy duty epoxy mortar floor system finished smooth.

USES

Suitable for heavy duty applications in all industries; examples are car parks, work platforms, ramps, traffic aisles, shower rooms, wet food and beverage manufacturing plants, chemical processing plants, plating plants, printing and packaging, electronics and computer manufacturing plants, wafer fabrication plants and pulp and paper mills.

BENEFITS

  • Solventless system.
  • Chemical resistance.
  • High gloss hygienic finish.
  • Withstands light forklift traffic.
  • Excellent impact resistance.

TECHNICAL DATA

APPLICATION

SUBSTRATE REQUIREMENTS / PREPARATION

  • Concrete floor must be waterproofed and graded to specified levels and falls.
  • Concrete floor shall be cured for minimum twenty-one (21) days.
  • Chip off all cement droppings and cement overpours.
  • Degrease oil/grease contaminants with industrial degreaser.
  • Shotblast surfaces to achieve suitable surface profile.
  • Remove dust with industrial vacuum prior to application of coating.

APPLICATION PROCEDURES

  • Apply Polygard EP824 epoxy tack coat.
  • Immediately apply Polygard EP826 as mortar base using power trowel and allow to dry for six (6) hours.
  • Apply Polygard EP826 as grout coat and allow to dry for six (6) hours.
  • Apply two (2) coats Polygard EP822 epoxy finish allowing six (6) hours drying time in between coats
  • Allow twenty-four (24) hours drying time before opening to light foot traffic and seven (7) days for chemical service conditions.

SAFETY REQUIREMENTS

Products contain epoxy resin and amines. Do not take internally. May irritate eyes and skin. Protective clothing and gloves are recommended to prevent sensitization to these materials. In case of eye contact, flush with soap and clean water and seek medical attention.

TECHNICAL ASSISTANCE

ECOGARD® MTX 5020 Floor System should be applied by specialist applicators. Technical advice or assistance on suitability of system for specific application and end-user requirements are available from POLYMER INTERNATIONAL HOLDING PTE LTD. Individual Product Data Sheets are available upon request.

The statement provided concerning the materials shown are intended solely as a general guide for material usage and are believed to be true and accurate. Since the manner of use is beyond our control, POLYMER INTERNATIONAL HOLDING does not make nor does it authorize anyone to make any warranty of merchant ability or fitness for any purpose or any other warranty, guarantee or representation, express or implied, concerning this material except that it conforms to POLYMER INTERNATIONAL HOLDING product sample. Buyer and user except the product under these conditions and assume the risk of any failure, injury of person or property and loss or liability resulting from the handling, storage or use of the product, whether or not handled, stored or used in accordance with directions or specification. Under no circumstances shall POLYMER INTERNATIONAL HOLDING be liable for consequential or incidental damages arising from any breach of warranty. In all cases, POLYMER INTERNATIONAL HOLDING liability is limited, at POLYMER INTERNATIONAL HOLDING option, to the replacement of goods or their value, proven to be defective in manufacturing.